What's a low tech way to clean up S&S couplers after brazing them in? Mine look like tarnished silverware right now. Remember, I'm asking for low tech.
Thanks, Chuck Lathe
Franklinville, NC
What's a low tech way to clean up S&S couplers after brazing them in? Mine look like tarnished silverware right now. Remember, I'm asking for low tech.
Thanks, Chuck Lathe
Franklinville, NC
a Scotchbrite type abrasive belt. The 3-M stuff is good, but it is expensive. We use stuff from ARC abrasives. Very low tech. Another option for a softer look is a Nylon brush wheel. Looks kind of like a wire wheel, but the bristles are made of nylon instead of steel wire. Good luck.
Tom Kellogg
Rides bikes, used to make 'em too.
Spectrum-Cycles.com
Butted Ti Road, Reynolds UL, Di2, QuarQ, Conour lite, SP Zero
Steel Cross, X-7, Crank Bros, Concour Lite, Nemesis, Grifo
Steel Piste, D-A Piste, PD-7400, Concour lite, Zipp 404
http://kapelmuurindependent.be
Shortest TFC Member (5'6 3/4") & shrinking
Thanks Tom, the Scotchbright does it.
Chuck
Bookmarks