So what is the trick to pulling the braze material all the way through the lug? I am having a real tough time getting that to happen. I realize it's not an easy task, but I think there is something I'm missing. So far, I'm a master at getting the brass at the top of the joint, but never see any being pulled through to the bottom. The material seems to end up running down the outside of the lug rather than through the inside. Is the sleeve too tight? I seem to be much better at fillet brazing that lug brazing.
I think my heat is adequate and I'm trying to heat up the all around the brass to get it to flow where I want; but nada.
Any tips you might be able to offer? I could use some.
Thanks in advance.
Bookmarks