FS: Home made main tube mitering system

[RCP FAB]

I have decided to sell my main tube mitering system, I need something that is faster to set up. This takes some time to get a bunch of tubes to come out the exact same.

Has mounting holes for the V block and also Anvil's seat stay mitering fixture.

I made the plate long enough to build something to keep the notches in phase, but never built it. It will do 0 deg to upwards of 80.

Make me an offer on it, but make it somewhat reasonable, the v block and materials weren't exactly cheap.

Pics are here: https://picasaweb.google.com/1095916...eat=directlink

Thanks for looking

[RCP FAB]

Looking to get what I have into it for materials and the V block set up, but feel free to make me an offer, I don't want to make money off of it, I would like to see it get used by someone.

The V block was about $100, and I probably have $200 into materials and hardware.

[Dallas Tex]

FWIW, you may want to post some pictures of it 'in action'. I went to the link too, I didn't see any pics of the complete system with a tube loaded in getting busy. Maybe I am not looking in the right place. I know its not hard to imagine, but folks like to see it.

[RCP FAB]

Not a problem, these are some from when i built it

[RCP FAB]

Sold. Thanks