Tig workstand height

[Amaro Bikes]

Hi all

Just curious to know what is your Tig welding workstand clamp height of ground?

Thanks

[Rody]

...about this high

Mag photo 17.JPG

Of course that changes as I rotate the fixture, nice that all joints can be accessed easily from a sitting position.


rody

[VertigoCycles]

Aimar,

I think mine's is set around 40" or so usually but it's adjustable and I move it often. I use the EVT Right Arm stand and love that I can align the joint I'm working on with the axis of rotation...that way I can rotate the frame and the joint is the same height all the time.

Dan's frame is all done with heat by VertigoCycles, on Flickr

[fortyfour]

Aimar-

From the center of my Park clamp to the floor is 42.5". For the record, I am 6'1" so depending on someones height, it might be a tad too tall? "Just So" for me though...

[abbeyQ]

My fab table is belly button high and work goes up from there. Most people think it's a really tall table but when you work off it you realize it's perfect. I will say that I'm pretty ape like with most of my height above the belt line. I will say if I had to do it over I would have put a bottle jack into the mix so that I could adjust the work height. But I've yet to wish it was shorter. If you're welding frames out of a repair clamp they are super adjustable and height is less of an issue.